AntMiner D3 15GH/s X11 ASIC Dash Miner

Price: $1,399.99
You Save: $50.01
(as of 11/21/2017 11:51 UTC - Details)
Product Description
Product Features

Hash rate: 15 GH/s plus or minus 5percent
Power consumption: 1200Watt. Power consumption also depends on your Power supply units efficiency.
Dimensions: 14inch x 5inch x 8inch
Hashing algorithm: X11
Compatible Coins: DASH, ADZ, ARC, ATX, BOLI, BOPS, BSC, CANN, CNO, CNT, COXST, CREVA, CRM, DP, ENT, ERY, FAL, GILL, GRN, HCC, HPC, INFX, J-x11, KASH, KURT, LGBTQ, LKC, MAR, MARX, MMM, MND, MUE, OGN, ONX, OZC, PIZZA, PXI, SAND, SEV, SMC, START, TOR, TREAU, UIS-x11, VLTC, XCXT, XVP

POWERSUPPLY IS NOT INCLUDED
Suggested Power Supplies: BITMAIN APW3++ PSU, BITMAIN APW5, and EVGA’s SuperNova 1600 G2.
All PCIe connectors on a hashing board need to be connected to the PSU for the hashboard to operate. Do not connect more than one PSU to the same hashing board!
Separate power supply to control board: there is one additional 6pin PCIe connector on the IO board which must be connected to the PSU to get power. Be sure to power on the miner only after all the PCIE connectors are connected to power supply.

WARRANTY EXCLUSIONS:
Overclocking will void all warranties
Customer removes/replaces/modifies any components by himself
Damage caused by poor power supply, lightning or voltage surges
Burnt parts on hash boards or chipsCustomer removes/replaces/modifies any components by himself
Miner/boards/components damage due to water immersion or corrosion due to wet environment.Customer removes/replaces/modifies any components by himself

Reach out to the seller immediately if a failure occurs to begin troubleshooting or processing a return. The 180-day manufacturer’s warranty will require the Amazon Seller’s Order ID. Reaching out directly to the manufacturer without the aid of the Amazon Seller will void all warranty of the device.

  • Hash Rate: 15 GH/s (Variation of 5 percent is expected)
  • Power consumption: 1200W (at the wall, with APW3 plus plus PSU, 93 percent efficiency, 25C ambient temperature)
  • Hashing algorithm: X11
  • Power consumption figures will vary with your PSU's efficiency, the ambient operating temperature and the accuracy of the power meter. It recommends use of the APW3 plus plus PSU with the Antminer D3. One AWP3 plus plus can not power more than one Antminer D3
  • All PCIe connectors on a hashing board need to be connected to the PSU for the hash board to operate. Do not connect more than one PSU to the same hashing board. Separate power supply to control board: there is one additional 6pin PCIe connector on the IO board which must be connected to the PSU to get power. Be sure to power on the miner only after all the PCIe connectors are connected to power supply.
Facebooktwittergoogle_plusredditpinterestlinkedinmail